جديدة أرضية متحركة Fliegl SDS 390

Description: Walking floor
Functionality: fully functional
Location: Oberpöllnitzer Straße 8, 07819 Triptis, Deutschland
1st axle: automatic lift axle, including forced lowering and starting aid, actuated by 3x braking (starting aid functional up to an axle load exceeding 30% and a speed of max. 25 km/h)
Note: A 2-circuit hydraulic system is required!
Flow rate: 110 l/min
Pressure: 250 bar
Minimum oil tank filling: 100 l
Achsenkonfiguration: 3 axles
Additional information
Chassis
Fine-grained steel welded construction in lightweight design
extending to the support legs
kingpin plate with 2 replaceable kingpins
Lateral floor preparation for lashing eyes
24-ton
two-speed support legs
single-sided operation
with straight lower part
without shock absorption
Extendable ladder at the rear
Door latch on the side
2 wheel chocks with holder
Aluminum side impact protection
Steel underrun protection with wide Fliegl mud flaps
foldable mudguard for lighting unit
Quarter panel fenders
Rear impact protection
Aluminum ladder approx. 3,550 mm
with holder on the side
Tarpaulin rod with holder
1 plastic toolbox
with drawer and insert
b=650 / h=520 / d=670 mm
lockable with a padlock (padlock not included)
1 spare wheel holder for 1 spare wheel
with wheel fastening kit
Axles + Suspension
SAF disc brake axles with 430 mm disc diameter
Axle/suspension laser-aligned to reduce tire wear and fuel consumption
Braking system
2-line compressed air braking system
color-coded lines for easy maintenance
Spring brake parking brake
2 fail-safe coupling heads at the front
without connection line
Electronic Braking System with EBS socket at the front
without connection cable
With raise and lower valve
Vehicle - Driving stability system
Wheels and tires
385/55 R22.5
according to manufacturer's choice
Steel rims
factory silver
Electrical system
24 Volt
multi-chamber lights
yellow LED lighting on the side
2 white position lights at the front
2 white/red side marker lights at the rear
2 x 7-pin and 1 x 15-pin fail-safe sockets at the front
without connection cable
Hydraulic cylinder with sliding mechanism installed in the floor
2-circuit hydraulic system
Switching between forward/backward movement electrically via remote control with cable
Sliding floor power supply via parking lights
Actuation hydraulically via truck PTO
Nsbyr Rei Riywsbgyswk
Hydraulic connection with hose at the front wall and HDK screw connector NW = 48 mm
Recommended pump output
Sliding floor
Sliding floor with wear plate at the rear
Floor boards made of aluminum
8 mm floor profile
ribbed design
Tipping body
Aluminum tipping body made of high-quality
abrasion-resistant material. Front and side walls made of aluminum hollow profiles
welded together at the top all around with a wide special reinforcement profile made of aluminum
welded to a special frame at the bottom
Sliding wall for better unloading of the load
with reinforced tarpaulin flaps at the bottom
with rail cleaner
Rear wall made of aluminum hollow profiles
as a 2-wing door
with a division of 1/2 to 1/2
framed all around with a special U-profile with stop and rubber seal
with 2 pieces of externally mounted swivel bolts
locked at the top and bottom. Rear wall with mechanical safety locking
operation at the rear on the driver's side. With pivoting crossbar at the top. The door locks can be locked with a padlock
Standing platform with access ladder on both sides in driving direction left/right and railing
for opening